Contacts I have made are not showing up in my Outbox.

HRD intetrnet options are configured.

DM780 says the data was sent to eQsl.

---

KC6KGE Steven L. Hess

Steven,
Have you tried uploading those contacts as a seperate ADIF file? If that works, I would say there is an issue with the auto-upload from HRD. If that doesn't work, do you get an error message from eQSL every time HRD uploads a contact? If you do, what does the error say?
Good Luck,
Andy - n1ork

---

N1ORK Orest 'Andy' Zajac

I am also experiencing this. I was uploading automatically from DM780, did one in the morning and that evening, it did not upload. Now I have to manually upload from the DM780 log to get it to go to eQSL. Then it uploads. I have changed nothing in HRD or DM780, so I suspect EQSL is not receiving them correctly. The DM780 also reports sucessful. I get no error message from Eqsl or HRD or DM780. Just nothing shows up until I send manually. This begs the question, also, does eQSL filter duplicates, so if it DOES show up, and I also resend it manually, that 2 cards are not generated?

Any help will be appreciated. Any solution wil be VERY welcome.

---

KJ4DGU Timothy Kaylor

Hi Timothy ,
to your question of duplicates :
I got two QSLs for exact the same QSO so it seems that duplicates are not eliminated at least not if there is a minute difference although i was told that the range should be about 1 hour . Well , no problem I think, just delete one , although time was different and 2 QSLs were shown , I was not asked to verify again , although I send one card only and both were shown as verified in the inbox from my side .

Uploading via DM780 I did NOT get an error message at the upload itself but looking later into the details of the QSO I was surprised to see that programme wrote : error , not submitted and it was NOT logged in eQSL .
So there really seems to be a problem of not being informed corretly in case of failure .

73 Uli

---

member of DARC , DOK M10 ( Grömitz )
EPC #2025 , 30MDG#0643
http://www.mydarc.de/dg7lae